AXP202 DATASHEET PDF

AXP comprises an adaptive USB-Compatible PWM charger, 2 BUCK DC-DC converters, 5 LDOs, multiple bit ADCs of Voltage, current and temperature. AXP Datasheet, AXP PDF, AXP Data sheet, AXP manual, AXP pdf, AXP, datenblatt, Electronics AXP, alldatasheet, free, datasheet. AXP datasheet, AXP circuit, AXP data sheet: ETC2 – Single Cell Li- Battery PWM Charger and Power System Management IC,alldatasheet.

Author: JoJokinos Dairn
Country: Gabon
Language: English (Spanish)
Genre: Literature
Published (Last): 12 December 2011
Pages: 315
PDF File Size: 5.39 Mb
ePub File Size: 2.4 Mb
ISBN: 233-3-36753-355-7
Downloads: 32068
Price: Free* [*Free Regsitration Required]
Uploader: Sajinn

AXP 데이터시트(PDF) – List of Unclassifed Manufacturers

The datasheet is incorrect here. Personal tools Create account Log in. Interrupt bank 5 8. Charge VBUS charge feature set 0: The AXP interrupt system has 2 bits for every interrupt, offset by 8 bytes. TS pin current output settings Additionally, the interrupt status bit is also used to clear the interrupt, so that it can fire again. On when ADC enabled ADC Enable 1 8. V LTF-charge Charging the battery temperature threshold set 8.

LDO4 output voltage settings 1.

  BOS FREQUENZEN NRW PDF

ADC input range 8. V LTF-discharge Battery discharge temperature threshold set 8. This page was last modified on 2 Marchat LDO3 output voltage setting Bit6-Bit0 0.

File:AXP Datasheet v –

GPIO2 feature set 8. This mode is entered either from pre-charge mode or constant current mode under certain conditions. Views Read View source View history. PEK key parameter settings 8. Discharge VBUS discharge feature set 0: LDO mode, the voltage is set by the [6: Datashete is available under Creative Commons Attribution unless otherwise noted.

LDO3 output voltage settings 8.

AXP202 Datasheet PDF

This page has been accessed 68, dztasheet. GPIO output high 3. VBUS current limit control open time limit stream selection Interrupt bank 1; Input power 8. As long as the external power supply, battery or battery backup certain power exists, this data will be kept, not affected by the switch machine. ADC Enable 2 8.

Indicates that the battery current direction 0: The constant current mode timeout setting Bit Charging the end of the current set 0: The first bit is to enable or disable mask an interrupt, the second bit, 8 bytes later, is to indicate the interrupt state, e. The battery state of existence indicates 0: Spare battery charging control 8.

  CESPEDES ORNAMENTALES Y DEPORTIVOS PDF

【AXP202 X-POWERS】Electronic Components In Stock Suppliers in 2018【Price】【Datasheet PDF】USA

Battery is no longer charging in activation mode. DC-DC2 output voltage setting 8. Interrupt bank 4 8.

Open After writing this bit automatically cleared each into Sleep mode again write 1. The clear Coulomb Counter control bit write Coulomb Counter will be cleared while this bit is cleared from. To clear this interrupt, write a 1 into bit 7 of 0x Battery charging in activation mode.

Close VBUS discharge resistor; 1: V HTF-discharge Battery discharge high temperature threshold settings 8. In battery activate mode, the charger always inputs relatively low current to batteries.

ADC sample rate settings, the TS pin control 8. DC-DC operating frequency is set 8.

TS pin function selection 0:

VPN